It’s a combination of the kid in me and the maker in me but getting a 3D Printer has been on my short list of things I want to get for years now. I’ve spent a lot of time with things like my plotter designing and making my own stickers as needed. Frankly though 3d printer always felt a little unobtainable both because of the cost and because it seemed like you might need an engineering degree to build and maintain one. Well a few months ago my interest was renewed and I decided that I was going to get one and from then on I spent day and night learning as much as I can, reading anything and everything. I had a few printers in mind but couldn’t decide. One of the companies I was keeping a close eye on was SeeMeCNC, they had been involved with printers for custom PC builds with Darth Beavis, on the Vanilla Ice Project, and even involved with PDXLAN. The problem was for my first printer at least; I wasn’t really looking for a build it yourself kit. I feel capable of doing that, but I just really wanted to dive into it quickly rather than a long build time prior. The other problem was even in the kit form their printers were a bit higher than I was budgeting. Well when looking at them I found out that they are actually within a drive away and I reached out about visiting. It just so happened that they were also introducing their long awaited Eris, a smaller, cheaper, and more portable model that comes factory build. I went and visited their factory and picked up the first Eris and have been getting a feel for it all. Today I’m going to give a quick run through on what 3d printing is all about, go over my visit with SeeMeCNC, then tomorrow I will dive into the Eris and my overall experience with it.
You do software updates to get the most from favourite programs right? Updating a motherboard BIOS can in a timely manner is also critical. The guide to Flashing a Motherboard BIOS spells out the often complicated steps in plain english. PCSTATS Tips