Due to the close proximity of the RAM chips on my Ti200 card I was forced to push back the heat sink in order get the ICEBERQ to fit properly. At first, I thought I would be able to remove a few of the aluminum fins but I found that the clip would still rest on top of the heat sink. The only way around this was to remove the heat sink, attach the cooler, and then put the heat sink back on. The downside is that the memory chips are now not fully covered by the heat sink, which you can see above. For anyone looking to get the ICEBERQ I would recommend you first look at your video card and see how close the RAM chips are to the right pin hole.