Bring the rear plastic screen bezel up in preparation
for reinstalling the metal
frame screws and make sure the wires around the hinge are
routed correctly. At this point it's helpful to reference the pictures you took
during disassembly to figure out where the wires go (in this case,
the thin wires are for a Wifi antenna).
A small tool may be used to route the wires
around paths molded into the plastic bezel. Once the wires are back in position,
install the screw in the hole you marked with a dot during disassembly.
Repeat the process for the wires by the other hinge and
reinstall the screw. Finally, install the two final screws at the top of
the panel and replace any other electrical parts (ie. the case close sensor)
back in their original locations).
Tilt the whole screen backwards and forwards to check that the
wires don't bind or become pinched. Pinched wires may be damaged, so reference
your disassembly photos to ensure they are routed correctly.